BWTFG - EZ ACE WELD MULTIPURPOSE SOLVENT CEMENT

  • MSDS: BWTFG
  • Manufacturer: PCI INDUSTRIES INC
  • Product Name: EZ ACE WELD MULTIPURPOSE SOLVENT CEMENT
  • National Stock Number: 8040-00F008240
Product Identification

Product ID:EZ ACE WELD MULTIPURPOSE SOLVENT CEMENT
MSDS Date:01/01/1989
FSC:8040
NIIN:00F008240
MSDS Number: BWTFG

Responsible Party
PCI INDUSTRIES INC
1661 OLD DIXIE HWY
RIVIERA BEACH, FL 33419-5000
US

Emergency Phone: 407-844-0241

Info Phone: 407-844-0241

Preparer: HARRY AUSTIN

Cage: FO174

Contractor
PCI INDUSTRIES INC
9845 RIVIERA BEACH, FL 33419 US

Telephone: (407) 844-0241

Cage: FO174

Ingredients

CYCLOHEXANONE, KETOHEXAMETHYLENE

CAS: 108-94-1

RTECS: GW1050000

Fraction By Weight: 8%

OSHA PEL 25 PPM

ACGIH TLV: 100 MG/CUM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


CHLORINATED POLYVINYL CHLORIDE, PYROLYZATE, CPVC

CAS: 68648-82-8

RTECS: FO1930000

Fraction By Weight: 15%


TETRAHYDROFURAN

CAS: 109-99-9

RTECS: LU5950000

Fraction By Weight: 35%

OSHA PEL 200 PPM

ACGIH TLV: 590 MG/CUM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


2-BUTANONE (METHYL ETHYL KETONE) (MEK)

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 42%

OSHA PEL 200 PPM

ACGIH TLV: 590 MG/CUM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

Hazards

Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: IRRITATION, BURNS, POSSIBLE
TRANSIENT CORNEAL/CONJUNCTIVAL INJURY. SKIN: SLIGHT/SEVERE
IRRITATION. INHALATION: NASAL/RESPIRATORY IRRITATION.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, REDNESS, TEARING, BLURRED VISION,
DEFATTING, DRYNESS, HEADACHE, GI IRRITATION, NAUSEA, DIZZINESS,
VOMITING, DIARRHEA, BURNS, RASH, INCOORDINATION, STUPOR, DIARRHEA.

First Aid

First Aid:EYES: IMMEDIATELY FLUSH W/PLENTY OF WATER FOR 15 MINS. SKIN:
WASH THOROUGHLY W/MILD SOAP & WATER. INHALATION: REMOVE TO FRESH
AIR. GIVE CPR/OXYGEN IF NEEDED. KEEP WARM & QUIET. INGESTION:
ASPIRATION H AZARD. DON'T INDUCE VOMITING. IF CONSCIOUS DILUTE BY
GIVING 2 GLASSES OF WATER. KEEP WARM & QUIET. OBTAIN MEDICAL
ATTENTION IN ALL CASES.

Fire Fighting

Flash Point Method:TCC
Flash Point:6F
Lower Limits:2
Upper Limits:12
Extinguishing Media:ALCOHOL RESISTANT FOAM, CO2, DRY CHEMICALS
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS W/FULL
FACEPIECE OPERATED IN PRESSURE DEMAND/OTHER POSITIVE PRESSURE MODE.
T
Unusual Fire/Explosion Hazard:VAPORS ARE >THAN AIR & MAY TRAVEL ALONG
GROUND/MAY BE MOVED BY VENTILATION & IGNITED BY PILOT LIGHTS &
OTHER IGNITION SOURCES AT DISTANT FROM HANDLING POINT.

Accidental Release

Spill Release Procedures:SMALL: ABSORB W/EARTH/SIMILAR INERT MATERIAL &
DISPOSE. FLUSH AREA W/WATER. LARGE: ERECT TEMPORARY/PERMANENT DIKE
TO CONTAIN. COLLECT & DESTROY BY LIQUID INCINERATION. OTHERWISE,
DILUTE W/WATER & USIN G INERT ABSORBENT MATERIAL. (SEE SUPP)

Handling

Handling and Storage Precautions:KEEP AWAY FROM HEAT/SPARKS/FLAME. KEEP
CONTAINER CLOSED. USE W/ADEQUATE VENTILATION.
Other Precautions:AVOID BREATHING VAPOR. AVOID CONTACT W/EYES, SKIN &
CLOTHING. CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN EMPTIED
SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUES. ALL HAZARD
PRECAUTIONS GIVEN I N DATA SHEET MUST BE OBSERVED.

Exposure Controls

Respiratory Protection:WEAR NIOSH/MSHA APPROVED AIR SUPPLIED
RESPIRATOR.
Ventilation:IF USED IN A CONFINED AREA USE GENERAL/LOCAL EXHAUST
VENTILATION.
Protective Gloves:RUBBER, BUTYL/IMPERVIOUS
Eye Protection:CHEMICAL SAFETY SPLASH GLASSES
Other Protective Equipment:EYE BATH, SAFETY SHOWER, FACE SHIELD, RUBBER
SAFETY BOOTS.
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
SPILL PROCEDURES CONT'D: SHOVEL INTO CONTAINERS TO BE DISPOSED OF AS
SOLID WASTE ACCORDING TO STATE, FEDERAL & LOCAL REGULATIONS.

Chemical Properties

Boiling Pt:B.P. Text:150F
Vapor Pres:114
Vapor Density:2.5
Spec Gravity:0.9
Evaporation Rate & Reference:(N-BU AC =1): -4
Solubility in Water:60%
Appearance and Odor:LIGHT YELLOW COLORED LIQUID W/STRONG SOLVENT ODOR
Percent Volatiles by Volume:85

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:IGNITION SOURCES, HEAT, SPARKS, FLAMES.
Hazardous Decomposition Products:NONE

Disposal

Waste Disposal Methods:DISPOSE OF IAW/FEDERAL, STATE & LOCAL
REGULATIONS. IF PERMITS & REGULATIONS ALLOW MAY BE INCINERATED,
ALLOWED TO EVAPORATE/SOLIDIFIED W/INERT MATERIAL & DISPOSE OF.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.